Bo Bunny Tag and Slip Cover
Good Morning
Today we are sharing Pandy's tutorial with you.
Personal Impressions Products
BoBunny Zip-a-dee-doodle 6 x 6 papers
BoBunny Zip-a-dee-doodle Layered Chipboard embellishments
Step 1
Take
1 sheet of 6” x 6” paper and on the back draw a line from corner to corner to
find the centre of the paper.
My tag is 6cm wide so I marked along each side of the
centre line just over 3cm – and scored down these lines.
Step
2
Fold
over and crease well.
Score
and crease the top point along the space between the points.
Score and crease the bottom about 1cm above the points
Step 3
You will need to trim off the point
of the paper that is going to be on the inside of the wrap – the point of the
other side will wrap round to the back side.
Trim the bottom flap off to leave
about 1cm – and trim the paper from the inside of the bottom flap.
You will end up with a shape
something like this – the dashed lines are the folds.
Step
4
Use
double sided tape the secure the wrap front – the bottom flap – the top flap
down.
Step
5
To
make the paper ribbon.
Stick
a strip of double sided tape across the length of a 6” paper.
Trim
the paper and tape at the same time to the width you require – 1cm / 1.5cm
Step
6
Fold the paper ribbon in half.
Step 7
Tear off half the backing strip and lay the tag cover
onto the side with the backing strip still on. That way you can get the
paper ribbon exactly where you want it to sit before you finally stick it down.
Step 8
Trim
the paper ribbon to a point – add a chipboard embellishment.
Stamp / decorate the tag and pop inside the slip
cover.
Comments
Post a Comment